ADS-B now supported in beta 3.4 APM software for copter and planes

Native support for the uAvionix PingX ADS-B receiver is now available in beta of the 3.4 code for Copter, Plane and Helicopter. Below is the procedure for loading the firmware on your Pixhawk/APM autopilot to visualize ADS-B compliant aircraft in your operational vicinity.

  • Verify that you are running the latest version of Mission Planner
  • Open Mission Planner and click “Install Firmware” from the “Initial Setup” window
  • Use the Hot Key command “Ctrl Q” to access Beta/Trunk firmware (V3.4dev) and click load
  • Once the firmware update is complete, power cycle the autopilot
  • Verify a successful update by viewing “Flight Data–Message” window located in the bottom left corner of Mission Planner
  • Set ADSB_ENABLE to “1” in the Mission Planner parameters list
  • The default plug-in on the Pixhawk autopilot for pingRX remains TELEM2
0 Comments

Leave a reply

Your email address will not be published. Required fields are marked *

*

Drone Academy CONTACT US

We're not around right now. But you can send us an email and we'll get back to you, asap.

Sending

Drone Academy Thailand 

5th Floor 18/49 Ratchpruek Village Sukkhaprachasun Rd. Bangpood  Prakred  Nonthaburi 11120 Tel: 02-963-3614

Log in with your credentials

Forgot your details?

Inline
Inline